3Com WX2200 3CRWX220095A Switch User Manual


 
308 CHAPTER 13: CONFIGURING USER ENCRYPTION
10 Configure a passphrase for the preshared key. Type the following
command:
WX1200# set service-profile wpa-wep-for-mac psk-phrase
"passphrase to convert into a preshared key"
success: change accepted.
11 Display the WPA configuration changes. Type the following command:
WX1200# display service-profile sp1
ssid-name: voice ssid-type: crypto
Beacon: yes Proxy ARP: no
DHCP restrict: no No broadcast: no
Short retry limit: 5 Long retry limit: 5
Auth fallthru: none Sygate On-Demand (SODA): no
Enforce SODA checks: yes SODA remediation ACL:
Custom success web-page: Custom failure web-page:
Custom logout web-page: Custom agent-directory:
Static COS: no COS: 0
CAC mode: none CAC sessions: 14
User idle timeout: 180 Idle client probing: yes
Keep initial vlan: no Web Portal Session Timeout: 5
Web Portal ACL:
WEP Key 1 value: <none> WEP Key 2 value: <none>
WEP Key 3 value: <none> WEP Key 4 value: <none>
WEP Unicast Index: 1 WEP Multicast Index: 1
Shared Key Auth: NO
WPA enabled:
12 Map service profile wpa-wep-for-mac to radio profile rp3. Type the
following commands:
WX1200# set radio-profile rp3 service-profile wpa-wep-for-mac
success: change accepted.
13 Apply radio profile rp3 to radio 1 on port 4 and to radios 1 and 2 on port
6 and enable the radios, and verify the configuration changes. Type the
following commands:
WX1200# set ap 4,6 radio 1 radio-profile rp3 mode enable
success: change accepted.
WX1200# set ap 6 radio 2 radio-profile rp3 mode enable
success: change accepted.