3Com WX2200 3CRWX220095A Switch User Manual


 
610 CHAPTER 27: MANAGING SYSTEM FILES
set log server 192.168.253.11 severity critical
set timezone PST -8 0
set summertime PDT start first sun apr 2 0 end lastsun oct 2 0
set system name WX1200
set system countrycode US
set system contact 3Com-pubs
set radius server r1 address 192.168.253.1 key sunflower
set server group sg1 members r1
set enablepass password b6b706525e1814394621eeb2a1c4d5803fcf
set authentication console * none
set authentication admin * none
set user tech password encrypted 1315021018
press any key to continue, q to quit.
To display only the VLAN configuration commands, type the following
command:
WX1200# display config area vlan
# Configuration nvgen'd at 2004-5-10 19:08:38
# Image 2.1.0
# Model WX1200
# Last change occurred at 2004-5-10 16:31:14
set vlan 1 port 1
set vlan 10 name backbone tunnel-affinity 5
set vlan 10 port 7
set vlan 10 port 8
set vlan 3 name red tunnel-affinity 5
set igmp mrsol mrsi 60 vlan 1
set igmp mrsol mrsi 60 vlan 10
Saving Configuration
Changes
To save the running configuration to a configuration file, use the
following command:
save config [filename]
If you do not specify a filename of up to 128 alphanumeric characters,
the command replaces the startup configuration file that was loaded the
last time the software was rebooted. (To display the filename of that
configuration file, see “Displaying Boot Information” on page 601.)
To save the running configuration to the file loaded the last time the
software was rebooted, type the following command:
WX1200# save config
success: configuration saved.