Filter
Top Products
144 CHAPTER 7: CONFIGURING SNMP
To set the minimum level of security MSS requires for SNMP, use the
following command:
set snmp security {unsecured | authenticated | encrypted |
auth-req-unsec-notify}
You can specify one of the following options:
unsecured—SNMP message exchanges are not secure. This is the
default, and is the only value supported for SNMPv1 and SNMPv2c.
(This security level is the same as the noAuthNoPriv level described in
SNMPv3 RFCs.)
authenticated—SNMP message exchanges are authenticated but are
not encrypted. (This security level is the same as the authNoPriv level
described in SNMPv3 RFCs.)
encrypted—SNMP message exchanges are authenticated and
encrypted. (This security level is the same as the authPriv level
described in SNMPv3 RFCs.)
auth-req-unsec-notify—SNMP message exchanges are
authenticated but are not encrypted, and notifications are neither
authenticated nor encrypted.
Command Example The following command sets the minimum level
of SNMP security allowed to authentication and encryption:
WX1200# set snmp security encrypted
success: change accepted.
Configuring a
Notification Profile
A notification profile is a named list of all the notification types that can
be generated by a switch, and for each notification type, the action to
take (drop or send) when an event occurs.
A default notification profile (named default) is already configured in
MSS. All notifications in the default profile are dropped by default. You
can configure up to 10 notification profiles.
To modify the default notification profile or create a new one, use the
following command:
set snmp notify profile {default | profile-name} {drop |
send} {notification-type | all}
To clear a notification profile, use the following command:
clear snmp notify profile profile-name