3Com WX2200 3CRWX220095A Switch User Manual


 
Configuring MAPs 241
Creating a New Profile
To create a radio profile, use the following command:
set radio-profile name [mode {enable | disable}]
Specify a name of up to 16 alphanumeric characters. Do not include the
mode enable or mode disable option.
After you create the radio profile, you can use the enable and disable
options to enable or disable all radios that use the profile.
To configure a new radio profile named rp1, type the following
command:
WX1200# set radio-profile rp1
success: change accepted.
To assign the profile to one or more radios, use the set ap radio
radio-profile command. (See “Assigning a Radio Profile and Enabling
Radios” on page 249.)
Changing Radio Parameters
To change individual parameters controlled by a radio profile, use the
commands described in the following sections.
You must disable all radios that are using a radio profile before you can
change parameters in the profile. (See “Disabling or Reenabling All Radios
Using a Profile” on page 250.)
Changing the Beacon Interval The beacon interval is the rate at
which a radio advertises its beaconed SSID(s). To change the beacon
interval, use the following command:
set radio-profile name beacon-interval interval
The interval can be a value from 25 ms through 8191 ms. The default is 100.
The beacon interval does not change even when advertisement is
enabled for multiple SSIDs. MSS still sends one beacon for each SSID
during each beacon interval.
To change the beacon interval for radio profile rp1 to 200 ms, type the
following command:
WX1200# set radio-profile rp1 beacon-interval 200
success: change accepted.