3Com WX2200 3CRWX220095A Switch User Manual


 
102 CHAPTER 5: CONFIGURING AND MANAGING PORTS AND VLANS
4 Configure ports 5 and 6 as wired authentication ports and verify the
configuration change. Type the following commands:
WX1200# set port type wired-auth 5,6
success: change accepted
WX1200# display port status
Port Name Admin Oper Config Actual Type Media
===============================================================================
1 mgmt up up auto 100/full network 10/100BaseTx
2 finance up up auto 100/full ap 10/100BaseTx
3 accounting up up auto 100/full ap 10/100BaseTx
4 shipping up up auto 100/full ap 10/100BaseTx
5 lobby up up auto 100/full wired auth 10/100BaseTx
6 lobby up up auto 100/full wired auth 10/100BaseTx
7 conf_room1 up up auto 100/full network 10/100BaseTx
8 conf_room1 up up auto 100/full network 10/100BaseTx
5 Configure ports 7 and 8 as a load-sharing port group to provide a
redundant link to the backbone, and verify the configuration change.
Type the following commands:
WX1200# set port-group name backbonelink port 7,8 mode on
success: change accepted.
WX1200# display port-group
Port group: backbonelink is up
Ports: 7, 8
6 Add port 1 to the default VLAN (VLAN 1) and verify the configuration
change. Type the following commands:
WX1200# set vlan default port 1
success: change accepted.
WX1200# display vlan config
Admin VLAN Tunl Port
VLAN Name Status State Affin Port Tag State
---- ---------------- ------ ----- ----- ---------------- ----- -----
1 default Up Up 5
1 none Up
4094 web-aaa Up Up 0
2 4094 Up
7 Save the configuration. Type the following command:
WX1200# save config
success: configuration saved.