Filter
Top Products
II CORE BLOCK: BCU (Bus Control Unit)
S1C33L03 FUNCTION PART EPSON B-II-4-25
A-1
B-II
BCU
DRAM Setting Conditions
The DRAM interface allows the following conditions to be selected. Although DRAM can be used in areas 8 and 7
or areas 14 and 13, these condition are applied to all four areas and cannot be set individually for each area.
Table 4.17 DRAM Interface Parameters
Parameter Selectable condition Initial setting Control bits
Page mode EDO page mode
or Fast page mode
Fast page mode REDO(DC)/Bus control register(0x4812E)
RAS mode Successive RAS mode
or Normal mode
Normal mode CRAS(D8)/DRAM timing set-up register(0x48130)
Column address size 8, 9, 10 or 11 bits 8 bits RCA[1:0](D[B:A])/Bus control register(0x4812E)
Refresh enable Enabled or Disabled Disabled RPC2(D9)/Bus control register(0x4812E)
Refresh method Self-refresh
or CAS-before-RAS
refresh
CBR refresh RPC1(D8)/Bus control register(0x4812E)
Refresh RPC delay 2.0 or 1.0 1.0 RPC0(D7)/Bus control register(0x4812E)
Refresh RAS pulse width 2, 3, 4 or 5 cycles 2 cycles RRA[1:0](D[6:5])/Bus control register(0x4812E)
Number of RAS precharge
cycles
1, 2, 3 or 4 cycles 1 cycle RPRC[1:0](D[7:6])/DRAM timing set-up register(0x48130)
CAS cycle control 1, 2, 3 or 4 cycles 1 cycle CASC[1:0](D[4:3])/DRAM timing set-up register(0x48130)
RAS cycle control 1, 2, 3 or 4 cycles 1 cycle RASC[1:0](D[1:0])/DRAM timing set-up register(0x48130)
Page mode
The DRAM interface allows EDO DRAM to be connected directly. Therefore, the EDO-page mode is
supported along with the fast-page mode.
Use REDO to choose the desired page mode that suits the DRAM to be used.
REDO = "1": EDO page mode
REDO = "0": Fast page mode (default)
Successive RAS mode
For applications that require high-speed DRAM access, the DRAM interface supports a successive RAS
mode. In this mode, even when successive accesses to the DRAM are not requested by the CPU or DMA, the
#RAS signal is kept low and operation is continued without inserting any precharge cycle. Therefore, when
accessing the same page (row address) of the DRAM that has been accessed previously, the page mode
remains active, allowing read/write to be performed at high speeds.
However, to maintain the rated AC characteristics, one idle cycle is inserted when access in the page mode is
begun and when finished.
CRAS is used to set the successive RAS mode.
CRAS = "1": Successive RAS mode
CRAS = "0": Normal mode (default)
The successive RAS mode is suspended by one of the following causes:
• a refresh cycle has occurred;
• bus control is requested by an external bus master;
• the requested device and page are not compatible with DRAM memory; and
• the slp or halt instruction is executed.
If the successive RAS mode is suspended, a precharge cycle is inserted before the next bus cycle begins.
Note: When using the successive RAS mode, always be sure to use #DRD for the read signal and
#DWE for the low-byte write signal.