Filter
Top Products
Communications Settings
11-6
11
System Manager Settings
<Divided Data RX Timeout>:
Specify the divided data TX timeout time by pressing [-] or [+].
<Subject>:
Press [Subject] ➞ enter a subject ➞ press [OK].
<Print MDN/DSN on Receipt>:
<Always send notice for RX errors>:
<Use Send Via Server>:
<Allow MDN Not Via Server>:
IMPORTANT
The maximum data size for sending must not be greater than the maximum data
size of the mail server.
NOTE
•
If you enter '0' MB as the data size, there is no size limit on the data that is sent.
•
If you set the divided data RX timeout time to '0', no divided data RX timeout time is
set.
•
For I-fax, when <Send Via Server> is set to 'Off', even if you enter the maximum
data size for sending, there is no size limit on the data that is sent.
•
The maximum data size for sending can be set in 1 MB increments. If the size of an
e-mail exceeds the set limit, the e-mail message is split up by page and sent out as
smaller e-mail messages, each of which is within the set limit. I-fax data that
exceeds the set limit is handled as an error, and is not sent. For more information,
contact your local authorized Canon dealer.
[On]: Notification e-mail messages (MDN/DSN) that inform you of the successful
delivery of jobs are printed.
[Off]: Notification e-mail messages (MDN/DSN) that inform you of the successful
delivery of jobs are not printed.
[On]: If an error occurs, the sender is always informed of the details of the error.
[Off]: If an error occurs, the sender is not informed of the details of the error.
[On]: Enables you to set whether to use the Send Via Server setting as a
condition to send to I-fax addresses.
[Off]: You cannot use the Send Via Server setting as a condition to send to I-fax
addresses.
[On]: Allows the sending of MDN (Mail Delivery Notification) mail without going
via a mail server.
[Off]: Does not allow the sending of MDN (Mail Delivery Notification) mail without
going via a mail server.