Filter
Top Products
Communications Settings
11-7
11
System Manager Settings
Fax Settings
This section describes settings that the System Manager can make, including how
to set the Send Start Speed, Receive Start Speed, RX (Receive) mode, and how to
register a password. It also describes how to set, change, and erase settings for
transferring received documents, and how to enable or disable certain settings.
NOTE
This mode is available only if the optional Super G3 FAX Board or Super G3 Multi-Line
Fax Board is installed.
■ Send/Receive Start Speed
This function enables you to change the send and receive start speeds, which is useful
when there is difficulty initiating the sending or receiving of a document.
■ Reception Password
This function enables you to set an optional ITU-T standard password. If a subaddress is
not set in a document that was received from another party using the ITU-T standard, an
RX password check takes place. If the RX password found does not match the RX
password set with this mode, or if an RX password is not attached to the document, the
document is not received.
NOTE
ITU-T stands for International Telecommunication Union-Telecommunication
Standardization Sector, which is the group that makes recommendations towards the
standardization of worldwide telecommunications.
1
Press (Additional Functions) ➞ [System Settings] ➞
[Communications Settings] ➞ [Fax Settings].