Filter
Top Products
xix
Users in Canada
Preinstallation Requirements for Canon Facsimile Equipment
A. Location
Supply a suitable table, cabinet, or desk for the machine. See Chapter 9,
"Appendix," in the Reference Guide for specific dimensions and weight.
B. Order Information
1. A single telephone line (touch-tone or rotary) should be used. If the optional
Super G3 Multi-Line Fax Board is installed, a dual telephone line (touch-tone or
rotary) can be used.
2. Order a CA11A modular jack which should be installed by the telephone
company. If the CA11A jack is not present, installation cannot occur.
3. Order a normal business line from your telephone company's business
representative. The line should be a regular voice grade line or an equivalent
one. Use one line per unit. If the optional Super G3 Multi-Line Fax Board is
installed, you can use a dual line.
DDD (Direct Distance Dial) line
or
IDDD (International Direct Distance Dial) line if you communicate overseas
NOTE
Canon recommends an individual line following industry standards, i.e., 2500
(touch-tone) or 500 (rotary/pulse dial) telephones. A dedicated extension off a PBX
(Private Branch eXchange) unit without "Call Waiting" can be used with your facsimile
unit. Key telephone systems are not recommended because they send nonstandard
signals to individual telephones for ringing and special codes, which may cause a
facsimile error.
C. Power Requirements
The power outlet should be a three-prong grounded receptacle (Single or Duplex).
It should be independent from copiers, heaters, air conditioners, or any electric
equipment that is thermostatically controlled. The rated value is 115 volts and 15
amperes. The CA11A modular jack should be relatively close to the power outlet to
facilitate installation.
Notice
• This product meets the applicable Industry Canada technical specifications.