Filter
Top Products
Communications Settings
11-4
11
System Manager Settings
Communications Settings
This section describes the e-mail, I-fax, fax, and Memory RX Inbox settings.
E-Mail/I-Fax Settings
You can change the e-mail and I-fax transmission settings. The following settings
are available.
■ Maximum Data Size for Sending
Sets the maximum data size for outgoing e-mail messages and I-fax documents. If an
e-mail message exceeds this data size limit, it is split up into several e-mail messages
before being sent. However, if an I-fax transmission exceeds the data size limit, it is
handled as an error, and it is not sent.
IMPORTANT
When sending an e-mail or I-fax document, you can set to divide the data before sending
it if the size of the data exceeds the maximum data size for sending.
NOTE
For information on dividing data before sending it, see "Specifying Destinations Using the
New Address Tab," on p. 2-2, and "Storing New Addresses," on p. 10-5.
■ Full Mode TX Timeout
Sets the time that elapses before sending operations terminate (automatically) if you do
not receive a notification e-mail message (MDN) from the recipient when you send an
I-fax in the Full Mode.
■ Divided Data RX Timeout
If it takes longer than the set Divided Data RX Timeout time to receive all the parts of a
divided I-fax document, only the data which has been received is combined to form the
document. Data which can be combined to form complete pages is printed, and any
remaining data is erased.
IMPORTANT
•
If you delete the divided data, it cannot be combined to form a document even if the
remaining divided data is received later.
•
Divided data cannot be printed as a regular image unless it has been combined.
•
If you select [Print When Erased] on the Divided Data RX Inbox screen for the Mail Box
function to print the data which is erased, the data will not be forwarded or stored in
memory. It will only be printed.