Filter
Top Products
Error Messages
13-10
13
Troubleshooting
No response from the server. Check the settings.
Cause The specified server settings are incorrect, or the server is not turned ON.
Alternatively, the machine's TCP/IP resources may be low.
Remedy Wait for a while, and then try browsing again. If there is still no response from
the server, try selecting another server.
NetWare is in use. Wait for a moment, then perform operation again.
Cause You cannot browse the network because NetWare is printing through a PServer
or NDS PServer.
Remedy Wait until printing is complete, and then try browsing again.
There are too many subdirectories.
Cause You have exceeded the maximum number of subdirectory levels allowed.
Remedy Specify a different destination because the directory level that you are trying to
access cannot be specified.
No response.
Cause 1 The server was not running when you tried to send.
Remedy Make sure that the server is ON, and check the destination.
Cause 2 The network connection was lost when you tried to send. (Either you could not
connect to the destination, or the connection was lost before the job could be
completed.)
Remedy Check the status of the network.
Cause 3 You tried to send via NetWare, but the Tree name was not entered.
Remedy Enter the Tree name.
Cause 4 A TCP/IP error occurred when you tried to send an e-mail message or I-fax.
Remedy Check that the network cables and connectors are properly connected.
Check the TCP/IP.
Cause The machine's TCP/IP connection is not operating.
Remedy Check the IP Address Settings (IP Address, DHCP, RARP, BOOTP) in TCP/IP
Settings in Network Settings in System Settings (from the Additional Functions
screen). (See Chapter 3, "Using a TCP/IP Network," in the Network Guide.)