Filter
Top Products
2-88
SET BPORT_MAU CONFIGURATION
SET BPORT_MAU
CONFIGURATION
Use the SET BPORT_MAU CONFIGURATION command to configure the protocol
you want a 10BASE-FB/FL SwitchModule MAU to use. By default, 10BASE-FB/FL
SwitchModule MAUs are set to autosense, which detects and adjusts to the
protocol (either 10BASE-FB or 10BASE-FL) being used on the network.
Format
Example
The following command forces mau 1 of port 2 on a 10BASE-FB/FL
SwitchModule in slot 6 to use the 10BASE-FB protocol:
CB5000> set bport_mau 6.2.1 configuration fb_force
Related Command
SHOW BPORT_MAU VERBOSE
set bport_mau configuration
fl_force
slot.
all
slot.port.mau
autosense
fb_force
slot.port.mau Identifies the MAU for this operation.
slot (1 through 17) is the slot number and port (1 through 20) is the
port number. Use 1 for the mau variable. For example, to identify port
4 on the module in slot 6, enter
6.4.1
slot.
all
.
mau Specifies that all MAUs in the slot are affected by this operation.
fb_force
Forces the port to always use the 10BASE-FB protocol.
fl_force
Forces the port to always use the 10BASE-FL protocol.
autosense
Causes the port to detect the protocol in use on the link and adjust to
match the protocol.