Filter
Top Products
SET BRIDGE_PORT SMT
2-101
SET BRIDGE_PORT
SMT
Use the SET BRIDGE_PORT SMT command to configure FDDI SwitchModule port
values. These values affect the FDDI ring Target Token Rotation Time (TTRT).
Refer to the CoreBuilder 5000 SwitchModule User Guide for more information
about SwitchModule FDDI port values.
Format
Example
The following command sets the treq_maximum value to 1000 for
SwitchModule FDDI port 1 in slot 6:
CB5000>
set bridge_port 6.1 smt treq_maximum 1000
Related Command
SHOW BRIDGE_PORT
slot.port Identifies the port for this operation.
The maximum port numbers are:
■
4 for FDDI SwitchModule (3C96604M-F)
■
14 for 10BASE-T and FDDI SwitchModule (3C96614M-FTP)
■
12 for 10BASE-FB/FL and FDDI SwitchModule (3C96612M-FF)
slot (1 through 17) is the slot number and port (1 through 24) is the
port number. For example, to identify port 4 on the module in slot 6,
enter
6.4
slot.
all
Specifies that all ports in the slot are affected by this operation.
tmax lower bound Value from 10.4860 through 1342.1777. The default value is
167.77216. This value that determines the boundaries for the Treq.
treq maximum Value from 0 through 1342.1777. The default value is 165.00736.
This is the value that each FDDI station issues for the TTRT election
process.
tvx lower bound Value from 0.02048 through 5.24288. The default value is 2.519040.
This value that resets to 0 when the beginning of a frame is detected.
slot.
all
set bridge_port smt
tmax lower bound
slot.port
tmax_lower_bound
treq_maximum
tvx_lower_bound
treq maximum
tvx lower bound