Filter
Top Products
2-80
SET BPORT_LEC MODE
SET BPORT_LEC MODE
Use the SET BPORT_LEC MODE command to cause an idle LAN Emulation Client
(LEC) to join the emulated LAN (ELAN) of which it is configured to be a member
or to cause an active LEC to disconnect from its emulated LAN.
This command controls the ability of the LEC to operate on an emulated LAN.
BPORT is an abbreviation for Bridge Port.
LEC ports are logical ports, all of which overlay one physical ATM/Synchronous
Optical Network (SONET) port.
Format
Example
The following command enables an active LEC in PHY in slot 4, port 1 to
disconnect from its emulated LAN:
CB5000> set bport_lec 4.1 mode enable
Bridge Port 04.01 parameter set.
Related Commands
SHOW BPORT_LEC CONFIGURATION
SET BRIDGE_PORT VBRIDGE
slot.lec Identifies the slot and LEC for this operation.
slot (1 through 17) is the slot number and
lec is one of up to 64 LAN
Emulation Clients defined as logical ports for the ATM Backbone
SwitchModule. For example, to identify LEC 32 on the ATM Backbone
SwitchModule in slot 4, enter
4.32
enable
Causes an idle LEC to attempt to join the emulated LAN of which it is
configured to be a member.
disable
Causes an active LEC to disconnect from its emulated LAN.
set bport_lec
mode
slot.lec
enable
disable