Filter
Top Products
2-54
SET ALERT
Example 1
The following command disables the DMM from sending traps when it executes
a script:
CB5000> set alert script disable
Alert SCRIPT set to DISABLE.
Example 2
The following command enables the DMM to send a trap whenever a user
makes a configuration change to the DMM:
CB5000> set alert change enable
Alert CHANGE set to ENABLE.
Example 3
The following command disables the DMM from displaying trap messages on
the terminal connected to the DMM:
CB5000> set alert console_display disable
Alert CONSOLE_DISPLAY set to DISABLE.
Related Commands
SET PORT ALERT
SHOW ALERT
hello
Enables or disables hello traps.
The DMM issues a hello trap when the DMM is reset, and then once
every minute until it receives a valid SNMP message. If the DMM has
not received a valid SNMP message after 4 hours and 15 minutes, it
stops sending hello traps.
The factory setting is hello traps enabled.
new_environment
Enables or disables new formatting of environmental alerts.
The DMM issues an environmental alert when there is a status
change in fans, power supplies, hub temperature, voltage levels, or
power reserve.
script
Displays a message on the locally connected terminal (screen) when
the DMM executes a script. The DMM never transmits a script alert
message.
The factory setting is script messages disabled.
port_up_down
Enables, disables, or filters port_up_down traps.
The DMM sends a port_up_down trap whenever a port on the stack
starts operating (goes up) or stops operating (goes down). The table
that follows shows how you can configure the port_up_down trap.
The factory setting is port_up_down traps disabled.
disable
Disables the specified trap.
enable
Enables the specified trap.
filter
Applies to port_up_down traps only. Refer to the following table.
Port_Up_Down Setting Result
enable
The DMM generates port up and port down alerts for all ports in
the hub.
disable
The DMM generates no port up and port down alerts.
filter
The DMM generates port up and port down alerts according to
the alert setting for each port.
Use the SET PORT ALERT command to configure port up and
port down alerts for specific ports.