Filter
Top Products
2-296
SET VBRIDGE STP MODE
SET VBRIDGE STP
MODE
Use the SET VBRIDGE STP MODE command to enable or disable the Spanning
Tree Protocol on a SwitchModule virtual bridge. By default, Spanning Tree is
enabled.
Disabling Spanning Tree can cause network loops and broadcast storms,
resulting in network failure. Refer to the CoreBuilder 5000 SwitchModule User
Guide for more information about Spanning Tree parameters.
Format
Example
The following command disables Spanning Tree on virtual bridge 9:
CB5000> set vbridge 9 stp mode disable
Spanning Tree Mode for vbridge 9 set to DISABLED. Setting saved.
Related Commands
SET VBRIDGE STP BRIDGE_FORWARD_DELAY
SET VBRIDGE STP BRIDGE_HELLO_TIME
SET VBRIDGE STP BRIDGE_MAX_AGE
SET VBRIDGE STP PRIORITY
SHOW VBRIDGE CONFIGURATION
vbridge The assigned virtual bridge number. Values are 1 through 240.
disable
Disable Spanning Tree on the virtual bridge you specify.
enable
Enable Spanning Tree on the virtual bridge you specify.
set vbridge
vbridge
stp
disable
mode
enable