Filter
Top Products
SET ATM NEIGHBOR IF_NAME
2-57
SET ATM NEIGHBOR
IF_NAME
Use the SET ATM NEIGHBOR IF_NAME command to specify the value of the
ifName for the peer ATM device’s ATM-layer interface.
Normally, this value is provided automatically by the peer through the Interim
Local Management Interface (ILMI). However, if the peer’s ILMI does not provide
this value, you can use this command to configure the value for network
management purposes.
The peer interface’s ifName is advertised in the ATM Backbone SwitchModule’s
RFC1695 ATM MIB.
Format
Example
The following command sets the neighbor if_name for the peer ATM device in
slot 4 to Test:
CB5000> set atm 4 neighbor if_name Test
Slot 04 parameter set.
Related Command
SHOW ATM INTERFACE
slot Identifies the slot for this operation.
slot (1 through 17) is the slot number.
option Use up to 63 characters for the ifName.
set atm
neighbor
slot
if_name
option