Filter
Top Products
2-350
SHOW MODULE
SHOW MODULE
Use the SHOW MODULE command to display the status and configuration for
modules currently installed in your hub.
The SHOW MODULE command displays information for all of the modules
currently installed in your hub. Use the VERBOSE option only when you use the
SHOW command with a single module in the hub. This option gives detailed
information about the software and DIP switch settings for the module.
To display information about port-switched modules, use the SHOW PORT
command.
This command has two additional values: RMON Analyzer and RMON System
Analyzer.
Format
Example 1
The following command uses the VERBOSE option to display the detailed
settings of the CoreBuilder 5000 24-Port 10BASE-T Module in slot 1. The first
line and the Module Information settings describe the software settings of the
module. The DIP Switch Information settings describe the hardware settings of
the module.
CB5000> show module 1.1 verbose
Slot Module Version Network General Information
----- --------------- ------- ---------- -------------------
01.01 6124M-TPL6 a1.00.5 PER_PORT
6124M-TPL6: CoreBuilder 5000 Ethernet 24-PORT 10BASE-T Module
Non-Volatile DIP Setting: DISABLED
slot Hub slot 1 through 19.
subslot Module subslot.
all
Displays information for all modules.
cpu_utilization
Displays CPU statistics for the specified module(s).
verbose
Displays extended information.
no_verbose
Displays summary information.
show module
slot.subslot
no_verbose
verbose
cpu_utilization
cpu_utilization
all