Filter
Top Products
2-194
SET PORT RING_SPEED
SET PORT RING_SPEED
Use the SET PORT RING_SPEED command to set either port on the ONline Token
Ring Bridge Module to operate at a transmission rate of 4 Mbps or 16 Mbps,
depending on the network ring speed.
This command enables you to set port 1 (backplane) or port 2 (front panel) on
the Token Ring Bridge Module to a transmission rate of 4 Mbps or 16 Mbps.
The DMM saves the setting for this command automatically. It is not necessary
to enter the SAVE command. Consequently, the REVERT command does not
affect the command setting. To change the setting, you must reenter the SET
command.
Format
Example
The following command sets port 1 of the Token Ring Bridge Module in slot 5
to 16 Mbps ring speed:
CB5000> set port 5.1 ring_speed 16mbps
Port 05.01 ring speed set to 16mbps.
Related Command
SET NETWORK TOKEN_RING RING_SPEED
slot.port Selects a port for ring speed setting.
slot (1 through 17) is the slot number location of a module in the hub
and port (1 or 2 ) is the port number on the specified module. For
example, to specify port 2 on the module with slot ID 6, enter
6.2
4mbps
Sets the ring speed on the port to 4 Mbps.
16mbps
Sets the ring speed on the port to 16 Mbps.
set port ring_speed
4mbps
16mbps
slot.port