Filter
Top Products
2-160
SET MODULE PROBE_MODE
SET MODULE
PROBE_MODE
Use the SET MODULE PROBE_MODE command to add and delete control table
entries for the following RMON groups:
■
Statistics
■
Host
■
Matrix
■
History
■
Host Top N
■
Events
■
Alarms
Enabling or disabling probe mode causes the Ethernet Network Monitor Card
(ENMC) to reset.
Setting an ENMC to probe mode prevents the ENMC from collecting per-port
statistics.
Format
Example
The following command enables probe mode on the ENMC module in slot 1.2:
CB5000> set module 1.2 probe_mode enable
Changing the probe mode causes this card to reset.
Also, any unsaved module changes will be saved.
Do you wish to continue ? (y/n) : y
Related Commands
SET RMON
SHOW RMON
SHOW COUNTER RMON
slot.subslot The slot and subslot of the ENMC that you are configuring.
enable
Enables the ENMC’s ability to act as an RMON probe. Enabling probe
mode disables the ENMC’s ability to collect per-port statistics.
disable
Disables the ENMC’s ability to act as an RMON probe. Disabling probe
mode enables the ENMC’s ability to collect per-port statistics.
set module
slot.subslot
probe_mode
enable
disable