Filter
Top Products
2-236
SET SECURITY PORT MAC_ADDRESS
SET SECURITY PORT
MAC_ADDRESS
Use the SET SECURITY PORT MAC_ADDRESS command to enter a MAC address
into the secure MAC address table. The secure MAC address table contains a
maximum of eight MAC addresses for each port in the hub.
When you enable security using the SET SECURITY PORT MODE command, the
DMM monitors each port for packets containing a source address not found in
the secure MAC address table for that port. If the DMM detects such a packet,
it takes action based on the settings of the SET SECURITY
ACTION_ON_INTRUSION command.
The following addresses are invalid for this command:
■
00-00-00-00-00-00
■
ff-ff-ff-ff-ff-ff
Format
Example
The following command enters MAC address 07-34-24-02-0F-00 into the secure
MAC address table for port 2 on slot 3:
CB5000> set security port 3.2 mac_address 07-34-24-02-0F-00
Security MAC address (noncanonical) 07-34-24-02-0F-00 on port
03.02.
Related Command
SET SECURITY PORT MODE
set security port
slot.port
mac_address
slot.
all
mac address
slot.port Identifies the port for this operation.
slot (1 through 17) is the slot number location of a module in the hub
and port is the port number on the specified module. For example, to
identify port 4 on the module in slot 6, enter
6.4
slot.
all
Specifies all ports on a module in a specified slot.
mac address MAC address to be entered into the secure MAC address table. Enter
the address as a series of six hexadecimal bytes separated by hyphens.
For example, 10-00-f1-0f-0c-63.