Filter
Top Products
2-412
SHOW TRUNK
SHOW TRUNK
Use the SHOW TRUNK command to display the status of Ring-In/Ring-Out
connections.
Format
Example
The following command displays trunk information on the module in slot 3:
CB5000>
show trunk 3.1 ring_in verbose
Trunk Display for Module 5208M-TP:
Slot Trunk Mode Status Type General Information
-----------------------------------------------------------------
03 RING_IN ENABLED NO SQUELCH COPPER Trunk is down
Trunk Connector:RJ45S
Trunk Mode Dip Setting:ENABLED
Cable Monitor: DISABLED
Cable Monitor Dip Setting:ENABLED
Network Map State:INTERNAL
Related Command
SET TRUNK RING_IN/RING_OUT
show trunk
slot.
1
no_verbose
verbose
trunk
all
slot.
1
Selects the hub slot (1 through 17) for this operation.
trunk Selects the trunk for this operation. The trunk port setting is required only
on fiber repeater modules.
ring_in.port
ring_out.port
backplane_in
backplane_out
no_verbose
Displays summary information. no_verbose is the default selection.
verbose
Displays extended trunk information.
Status Definition
OKAY Trunk is operating properly.
NO PHANTOM Port is not connected to an operating trunk port.
NO SQUELCH The trunk does not detect a signal from a remote Ring-In/Ring-Out
device.
BEACON WRAPPED Trunk is wrapped because the device connected to the trunk caused
a beaconing condition. While the trunk is wrapped, the trunk
software checks the trunk every 30 seconds and unwraps when the
remote device is ready.