Filter
Top Products
SET BRIDGE_PORT STP PATH_COST
2-103
SET BRIDGE_PORT STP
PATH_COST
Use the SET BRIDGE_PORT STP PATH_COST command to configure a Spanning
Tree Protocol path cost parameter for a SwitchModule bridge port. For more
information about Spanning Tree, refer to the CoreBuilder 5000 SwitchModule
User Guide.
Format
Example
The following command assigns a path cost value of 65000 to port 12 on the
SwitchModule in slot 3:
CB5000> set bridge_port 3.12 stp path_cost 65000
Related Commands
SET BRIDGE_PORT STP PRIORITY
SHOW BRIDGE_PORT
slot.port Identifies the port for this operation.
slot (1 through 17) is the slot number and port (1 through 24) is the port
number. For example, to identify port 4 on the module in slot 6, enter
6.4
slot.
all
Specifies that all ports in the slot are affected by this operation.
path cost Value from 1 through 65535. The default value is 1000 divided by the speed
of the link. For example, 1000 divided by FDDI link speed (100 Mbps) equals a
path cost value of 10.
slot.
all
set bridge_port
slot.port
path_cost
path cost
stp