Filter
Top Products
SET PORT SPEED_DETECT
2-195
SET PORT
SPEED_DETECT
Use the SET PORT SPEED_DETECT command to enable speed detection for a
CoreBuilder 5000 Token Ring port. This command prevents stations from
inserting on the ring at an incorrect ring speed.
Format
Example
The following command disables speed detection for port 2 on hub 1:
CB5000> set port 1.2 speed_detect disable
Port 01.02 Speed Detection set to DISABLED.
Related Commands
SAVE PORT
SHOW PORT
slot.port Selects a port for this operation.
slot (1 through 17) is the slot number location of a module in the hub
and port (1 through 20) is the port number on the specified module.
For example, to specify port 4 on the module with slot ID 6, enter
6.4
slot.
all
Selects a slot for enabling speed detection. For example, to specify all
ports on the module with slot ID 6, enter
6.all
disable
Disables speed detection for the identified port.
The factory setting is speed detection disabled.
enable
Enables speed detection for the identified port.
set port
slot.port
disable
enable
speed_detect
slot.
all