Filter
Top Products
SET BRIDGE_PORT VBRIDGE
2-105
SET BRIDGE_PORT
VBRIDGE
Use the SET BRIDGE_PORT VBRIDGE command to assign a SwitchModule bridge
port to a virtual bridge or create a new virtual bridge.
Format
Example
The following command assigns all ports on the SwitchModule in slot 3 to
virtual bridge 2:
CB5000> set bridge_port 3.all vbridge 2
Related Commands
SHOW VBRIDGE CONFIGURATION
SHOW BRIDGE_PORT
slot.port Identifies the port for this operation.
slot (1 through 17) is the slot number and port (1 through 24) is the
port number. For example, to identify port 4 on the module in slot 6,
enter
6.4
slot.
all
Specifies that all ports in the slot are affected by this operation.
vbridge Value from 1 through 240. If you assign a vbridge number that is not
yet used as a virtual bridge number, you create a new virtual bridge
that is automatically enabled to switch traffic.
slot.
all
set bridge_port
vbridge
slot.port
vbridge