Filter
Top Products
SET LOGIN
2-127
SET LOGIN
Use the SET LOGIN command to add users to and change passwords for the
CoreBuilder 5000 command interface. Any user can use this command to
modify his or her own password. You must be logged in as super user to use
this feature to create new logins.
The DMM allows up to 10 login names, so that you can authorize several users
with differing privileges. Passwords are case sensitive (that is, myname and
MYNAME are two different passwords).
You can assign user names at three access levels.
Newly set passwords are effective immediately. You are not prompted for a
password until you log out and then try to log back in. You must enter the
SAVE LOGIN command for the new user login names to be permanently saved.
If you lose or forget a user password, the super user can use the CLEAR LOGIN
and SET LOGIN commands to remove, then re-create the user name.
The factory setting is a single super-user account with the user name system
and no password.
A newly created login account is not available for use until you save it.
Format
set login
user
administrator
super_user
password
access
super_user
user
Creates a user login.
The user can use the following commands:
■
All SHOW commands
(except SHOW COMMUNITY)
■
CLEAR RMON
■
CLEAR COUNTERS
■
SET RMON
■
MONITOR