Filter
Top Products
SET MODULE IGMP_SNOOPING
2-143
SET MODULE
IGMP_SNOOPING
Use the SET MODULE IGMP_SNOOPING command to enable or disable IGMP
Snooping on a module. After you enter this command, it does not take affect
until the module is rebooted. The sole purpose of this command is to allow the
FTE based modules to share FTE Forwarding memory based on snooping versus
non-snooping bridges.
Format
Example
The following command enables IGMP Snooping on the module in slot 15:
CB5000> set module 15.1 igmp_snooping enable
IGMP Snooping set to ENABLED.
set module
slot.subslot
igmp_snooping
enable
disable
slot.
1
Selects the module on which you want to enable or disable IGMP
snooping. Valid values are hub slot 1 through 17, subslot 1.
enable
Enables IGMP snooping on the specifed module.
disable
Disables IGMP snooping on the specifed module.