SET MODULE RING_SPEED
2-161
SET MODULE
RING_SPEED
Use the SET MODULE RING_SPEED command to set the module to run at a ring
speed of 4 Mbps or 16 Mbps.
You can change the speed of a module only under the following conditions:
■
The module is isolated from other hubs (SET NETWORK).
■
No stations are connected to the module or all ports are disabled (SET PORT
MODE).
This command does not set the ring speed for module-switched
CoreBuilder 5000 Token Ring modules.
Format
Example
The following command sets the module in slot 5 to a ring speed of 16 Mbps:
CB5000> set module 5.1 ring_speed 16mbps
Ring Speed set to 16 MBPS.
Related Commands
SAVE MODULE
SHOW MODULE
SET NETWORK TOKEN_RING RING_SPEED
set module
slot.subslot
ring_speed
4mbps
16mbps
slot.sublsot Identifies the module for this operation.
4mbps
16mbps
Selects a ring speed of 4 Mbps or 16 Mbps. The factory setting is
16mbps.