Filter
Top Products
SET ATM QSAAL
2-63
SET ATM QSAAL
Use the SET ATM QSAAL command to specify the values of QSAAL parameters
.
3Com recommends that you do not change the default settings for this
command. Any changes may cause interoperability problems with other ATM
equipment.
Format
Refer to the ATM Backbone SwitchModule User Guide for definitions of
parameters and additional information.
slot Identifies the slot for this operation.
slot (1 through 17) is the slot number.
cc
Specifies (in seconds) the cc value.
option Choose from a range of 1 through 300. The default value for User
Network Interface (UNI) Version 3.0/3.1 is 2/1.
idle
Specifies (in seconds) the idle value.
option Choose from a range of 1 through 300. The default value for UNI
Version 3.0/3.1 is 15/15.
keepalive
Specifies (in seconds) the keepalive value.
option Choose from a range of 1 through 300. The default value for UNI
version 3.0/3.1 is 1/2.
max_cc_retries
Specifies (in seconds) the max_cc_retries value. Range is 1 through 4.
option Choose from a range of 1 through 4. The default value is 4.
max_pd_retries
Specifies (in seconds) the max_pd_retries value. Range is 1 through
25.
option Choose from a range of 1 through 25. The default value is 25.
no_response
Specifies (in seconds) the no_response value.
option Choose from a range of 1 through 300. The default value for UNI
Version 3.0/3.1 is 10/7.
poll
Specifies (in milliseconds) the poll value.
option Choose from a range of 100 through 10000. The default value for
UNI Version 3.0/3.1 is 100/750.
stat_max_ranges
Specifies (in seconds) the stat_max_ranges value. Range is 1 through
67.
option Choose from a range of 1 through 67. The default value is 67.
set atm
qsaal
slot
idle
keepalive
stat_max_range
option
option
option
option
option
option
option
option
cc
max_cc_retries
max_pd_retries
no response
poll