Filter
Top Products
2-244
SET SECURITY_ADVANCEDNETWORK INTRUDER_REPORTING
SET
SECURITY_ADVANCED
NETWORK
INTRUDER_REPORTING
Use the SET SECURITY_ADVANCED NETWORK INTRUDER_REPORTING command
to track intrusion attempts on an Ethernet network that has an Ethernet Private
Line Card assigned to it.
To track intrusion attempts on a secure network, you must enable the intruder
reporting network parameter. This parameter enables the Ethernet Private Line
Card to instruct a media module to report intrusion attempts on a secure
network. The DMM stores all reported intrusion attempts in the Intruder Table.
The Security Intruder Table has a limit of 100 intrusion entries. After the table
reaches the maximum limit, older entries expire automatically.
To report intruders on a secure network, you must enable the source address
checking or the source port checking network parameter. If you do not enable
either of these parameters, the system does not detect intruders.
Format
Example
The following command enables intruder reporting on ethernet_1:
CB5000> set security_advanced network ethernet_1
intruder_reporting enable
ETHERNET_1 Intruder Reporting: set to ENABLED.
Related Command
SHOW SECURITY_ADVANCED
ethernet_
1...8
Specifies which Ethernet network to apply this command.
isolated_
1...8
Specifies which isolated network to apply this command.
enable
Enables intruder reporting.
disable
Disables intruder reporting.
set security_advanced network
enable
ethernet_
1...8
intruder_reporting
disable
isolated_
1...8