Filter
Top Products
SHOW TR_SURROGATE REM_LAST_BEACON
2-403
SHOW
TR_SURROGATE
REM_LAST_BEACON
Use the SHOW TR_SURROGATE REM_LAST_BEACON command to show
information on the REM last received beacon. The REM Beacon Data Trap Table
displays information used to build a trap that describes the beacon type, physical
location, and fault domain of a beaconing station. Use the SHOW TR_SURROGATE
REM_LAST_BEACON command to show information about the most-recently
detected beacon condition on the ring.
Format
Example
The following command shows the REM last beacon received by the TR-NMC in
slot 11.2:
CB5000> show tr_surrogate 11.2 rem_last_beacon
Ring Error Monitor Last Received Beacon Data for Network
TOKEN_RING_1
--------------------------------------------------------------------
Beacon Type Signal Loss
Station Address 00-ff-00-00-00-00
Station NAUN Address 00-00-ff-00-00
Station Physical Location 00012345
Beacon Recovery Status None Left
show tr_surrogate
slot.
2
rem_last_beacon
slot.
2
The slot ID for the module that you selected for the operation. The slot
number can be from 1 through 17. The subslot is always 2.
Field Description
Beacon Type Indicates the type of beacon that occurred on the ring.
The options are:
■
Recovery Mode Set
■
Signal Loss
■
Token Not Claimed
■
Token Claimed
■
Invalid — Is displayed when there has not been a beacon recorded
Station Address If the ring is beaconing currently, this field displays the address of the station
transmitting beacon frames.
Station NAUN
Address
Displays the Nearest Active Upstream Neighbor of the station transmitting
beacon frames. This station is also referred to as the upstream station in the
beacon fault domain.
Station Physical
Location
Displays the physical location of the beaconing station.