Filter
Top Products
2-152
SET MODULE MEMORY_MODEL
SET MODULE
MEMORY_MODEL
Use the SET MODULE MEMORY_MODEL command to adjust the amount of
DRAM (dynamic random access memory) that a CoreBuilder 5000 SwitchModule
allocates to address learning and to RMON. Increasing the setting increases the
table capacity for RMON processing on the SwitchModule.
You must save the setting and reboot the SwitchModule for the change to take
effect.
For more information about altering the memory module setting, refer to the
CoreBuilder 5000 SwitchModule User Guide.
Format
Example
The following command changes the memory model setting to medium for the
SwitchModule in slot 5:
CB5000> set module 5.1 memory_model medium
CB5000> save all
Related Commands
SHOW MODULE
SET MODULE MAXIMUM_VBRIDGE
slot
.
1
Slot containing the SwitchModule you are configuring.
small
DRAM allocation for address learning and RMON = 3.5 MB.
This is the default setting. No memory upgrade SIMM necessary to use
this setting.
If you set memory model to Small, you cannot set the maximum
virtual bridge to a value to greater than 128 for this SwitchModule.
medium
DRAM allocation for address learning and RMON = 3.0 MB.
No memory upgrade SIMM necessary to use this setting.
large
DRAM allocation for address learning and RMON = 2.0 MB.
You can set the memory model to Large only if you have installed an
8 MB or 16 MB memory upgrade SIMM on the SwitchModule.
set module
slot.
1
memory_model
small
medium
large