Filter
Top Products
2-98
SET BRIDGE_PORT INTERFACE
SET BRIDGE_PORT
INTERFACE
Use the SET BRIDGE_PORT INTERFACE command to enable or disable interface
functions on SwitchModule bridge ports.
Format
Example
The following command disables port 6 on the SwitchModule in slot 4:
CB5000>
set bridge_port 4.6 interface disable
Related Commands
SET BPORT_MAU MODE
SET BRIDGE_PORT STP BRIDGE_MODE
SHOW BRIDGE_PORT
slot.port Identifies the port for this operation.
slot (1 through 17) is the slot number and port (1 through 24) is the port
number. For example, to identify port 4 on the module in slot 6, enter
6.4
slot.
all
Specifies that all ports in the slot are affected by this operation.
disable
Disables interface functions but leaves the physical interface enabled.
enable
Enables interface functions.
slot.
all
set bridge_port interface
disable
enable
slot.port