Filter
Top Products
2-174
SET PORT ALERT_FILTER
SET PORT
ALERT_FILTER
Use the SET PORT ALERT_FILTER command to enable or disable filtering of port
up/down trap generation for a specific port. This command works in
conjunction with the SET ALERT PORT_UP_DOWN FILTER command. The order in
which you enter these two commands does not matter.
After the PORT ALERT_FILTER has been set for a port, you must enter the SET
ALERT PORT_UP_DOWN FILTER command to filter or not filter port up and port
down traps on a per port basis, to be transmitted from the DMM to the
designated trap receiver.
If the filter is enabled, no traps are generated. If the filter is disabled, traps are
generated.
Format
Example
The following command enables port_up_down traps for port 2 on the module
in slot 6:
CB5000> set port 6.2 alert_filter enable
Port 06.02 Alert Filter set to ENABLED.
Related Commands
SET ALERT
SHOW ALERT
set port alert_filter
disable
enable
slot.
all
slot.port
slot.port Identifies the port for this operation.
slot (1 through 17) is the slot number and port (1 through 24) is the
port number on the specified module. For example, to identify port 4
on the 6, enter
6.4
slot.
all
Specifies that all ports in the module are affected by this operation.
disable
Disables filtering of port_up_down traps for the identified port.
The factory setting is disabled.
enable
Enables filtering of port_up_down traps for the identified port.