Filter
Top Products
SET PROTOCOLS FORWARDING
2-207
SET PROTOCOLS FORWARDING commands follow the DMM SET MODULE
command syntax (slot.subslot). SwitchModules use the value 1 for subslot.
When you enter the SET PROTOCOLS FORWARDING command, the DMM
interface prompts you for the necessary information.
Example 1
CB5000> set protocols 4.1 forwarding enet
Enter filter in hex: 60-03
Enter value in Hex (with dash dividing bytes).
Enter queue priority: normal_priority
high_priority
normal_priority
Enter forward to ports: all
all
none
pkt_chan_port
OR
(port)
Enter filter name: decnet
Filter set
This command configures an ENET filter for the SwitchModule in slot 4, sets it
to filter on all ports at normal priority, and names the filter decnet.
Example 2
The SwitchModule defines an unknown protocol as any protocol that is not a
default protocol in the protocol forwarding table. Use the SHOW PROTOCOLS
FORWARDING command to display the protocol forwarding table.
By default, SwitchModule ports forward all unknown protocols.
To filter (drop) unknown protocols, use the SET PROTOCOLS FORWARDING
command as follows:
CB5000> set protocols 7.1 forwarding unknown none
Enter filter name: Filter1
Filter set
This command filters unknown protocols at all ports on the SwitchModule in
slot 7.
This command deletes all user-created entries from the protocol forwarding
table for slot 4. The default protocol filters remain in the table.
For example:
> set protocols 4.1 forwarding to_defaults
Filters reset to defaults.
Related Command
SHOW PROTOCOLS FORWARDING