Filter
Top Products
RESET MODULE
2-47
RESET MODULE
Use the RESET MODULE command to perform a hardware reset of a module in
the hub. Use this command only if a module is not functioning properly. If used
for the main (.1) subslot, the command resets each submodule in the slot. The
DMM resets the module in the specified slot to its last-saved configuration.
When you enter this command for the main board in a slot (.1):
1
The system prompts you to confirm that you want to reset all modules in the
slot.
2
Press
y
to execute the reset.
You cannot reset either the DMM to which you are logged in or the Active
Controller Module using this command. To reset the DMM, use the RESET
DEVICE command. To reset the Active Controller Module, use the RESET HUB
command. The RESET HUB command resets all modules, including the Controller
Module.
Format
Example
The following command resets the main board, and any boards in subslots, on
the module in slot 6:
CB5000> reset module 6.1
Resetting this module will reset all of the modules in this slot.
Do you wish to continue ? (y/n) : y
Resetting module 6.1.
Related Commands
RESET HUB
SHOW MODULE ALL
slot Indicates the slot to reset: 1 through 19.
subslot Indicates the subslot to reset: 1 through 7.
reset module
slot.subslot