Filter
Top Products
SET ATM ILMI
2-55
SET ATM ILMI
Use the SET ATM ILMI command to configure the Interim Local Management
Interface (ILMI) ATM attributes associated with the module.
Format
Example
The following command sets the ILMI maximum burst size at 20 cells for the
module in slot 4:
CB5000> set atm 4 ilmi max_burst_size 20
Slot 04 parameter set.
Warning: Change does not take effect until module is reset.
Related Command
SHOW ATM ILMI CONFIGURATION
slot Identifies the slot for this operation.
slot (1 through 17) is the slot number.
admin_vbridge
Specifies the vbridge to be used for administrative purposes.
option Choose from a range of 1 through 240.
max_burst_size
Specifies the maximum burst size (in cells) for ILMI operations.
option Choose from a range of 1 through 100. The default value is 11.
peak_cell_rate
Specifies the peak cell rate as a percentage of line rate for ILMI
operations.
option Choose from a range of 1 through 100. The default value is 5.
pvc
Specifies (in vpi/vci format) the PVC Virtual Path Identifier/Virtual
Channel Identifier (VPI/VCI) to be used for ILMI operations.
option The format for this option is value/value. The default value is 0/16.
req_retries
Specifies the number of retries associated with ILMI operations.
option Choose from a range of 0 through 4. The default value is 2.
req_timeout
Specifies the timeout in seconds for ILMI operations.
option Choose from a range of 5 through 60. The default value is 5.
sust_cell_rate
Specifies the sustained cell rate as a percentage of line rate for ILMI
operations.
option Choose from a range of 1 through 100. The default value is 1.
set atm
ilmi
slot
peak_cell_rate
max_burst_size
pvc
req_retries
req_timeout
sust_cell_rate
option
option
option
option
option
option
admin_vbridge
option