Filter
Top Products
2-104
SET BRIDGE_PORT STP PRIORITY
SET BRIDGE_PORT STP
PRIORITY
Use the SET BRIDGE_PORT STP PRIORITY command to assign a Spanning Tree
Protocol priority value to a SwitchModule bridge port. For more information
about Spanning Tree, refer to the CoreBuilder 5000 SwitchModule User Guide.
Format
Example
The following command assigns a priority value of 200 to port 10 on the
SwitchModule in slot 3:
CB5000>
set bridge_port 3.10 stp priority 200
Related Commands
SET BRIDGE_PORT STP PATH_COST
SHOW BRIDGE_PORT
slot.port Identifies the port for this operation.
slot (1 through 17) is the slot number and port (1 through 24) is the port
number. For example, to identify port 4 on the module in slot 6, enter
6.4
slot.
all
Specifies that all ports in the slot are affected by this operation.
priority Value is an even number from 0 through 254. The default value is 128.
slot.
all
set bridge_port
priority
slot.port
priority
stp