Filter
Top Products
SET IP DEFAULT_GATEWAY
2-123
SET IP
DEFAULT_GATEWAY
Use the SET IP DEFAULT_GATEWAY command to specify the IP address of a
device (usually a router) that forwards packets to destinations other than the
local IP network.
Use the SET IP DEFAULT_GATEWAY command to specify a default gateway if the
DMM will be sending alert packets (SNMP traps) to management workstations
on other IP networks.
You must reset the DMM for the new default gateway addresses to take effect.
Format
Example
The following command configures a default gateway for virtual bridge 3:
CB5000>
set ip default_gateway 123.123.4.6 vbridge 3
Default
Gateway
associated
with
VBRIDGE
3
set
to 123.123.4.6.
Related Commands
SHOW IP
SET IP ACTIVE_DEFAULT_GATEWAY
set ip default_gateway
ip address
isolated_
1
through
_
11
token_ring_
1
through
_
10
fast_ethernet_
1 through 4
ethernet_
1
through
_
8
all
vbridge
1
through
240
ip address IP address of the default gateway. Enter the address as a
series of four decimal bytes separated by periods. For
example, 192.122.19.4.
isolated_
1 through
_
11
Default gateway address applies to an isolated network.
token_ring_
1 through
_
10
Default gateway address applies to the specified Token Ring
network.
ethernet_
1 through
_
8
Default gateway address applies to the specified Ethernet
network.
fast_ethernet_
1 through
_
4
Default gateway address applies to the specified Fast
Ethernet network.
all
Default gateway address applies to all hub networks.
vbridge
1
through
240
Default gateway address applies to a virtual bridge network.