Filter
Top Products
2-176
SET PORT AUTOSENSE
SET PORT AUTOSENSE
Use the SET PORT AUTOSENSE command to enable or disable the automatic
sensing feature. This command applies to the CoreBuilder 5000 EtherFlex
Module (Model Number 6104M-MOD) with a 10BASE-FB/FL I/O Card.
The autosense feature automatically determines the protocol (FB or FL) being
used on the network.
If autosensing is enabled, the protocol running on the port is shown by the
media sense field of the SHOW MODULE command, and not the media
configuration field.
Format
Example
The following command enables the autosensing feature on all ports on the
Etherflex module located in slot 1:
CB5000> set port 1.all autosense enable
AUTOSENSE mode set to ENABLE.
Related Command
SHOW PORT
slot.port Identifies the port for this operation.
slot (1 through 17) is the slot number location of a module in the hub
and port is the port number on the specified module. For example, to
identify port 4 on the module in slot 6, enter
6.4
slot.
all
Specifies that all ports on the module are affected by this operation.
disable
Disables the automatic sensing feature. When it is disabled, the media
configuration
field shows whether the port is using FB or FL protocol.
enable
Enables the automatic sensing feature. When it is enabled, the media
sense field shows whether the port is using the FB or FL protocol. The
FB/FL chip on the Fiber I/O card uses the media module sense to
determine the protocol on the line (either FB or FL).
set port autosense
disable
enable
slot.port
slot.
all