Filter
Top Products
2-276
SET TRUNK STATIC_SWITCH
SET TRUNK
STATIC_SWITCH
Use the SET TRUNK STATIC_SWITCH command to prevent the network
configuration of a trunk from being changed when either trunk in a pair (either
the Ring-In or the Ring-Out) is enabled. This prevents inadvertent changes to live
rings.
Because setting the network of a trunk simultaneously affects both members of
the trunk pair, this command works on a pair basis. Enabling or disabling the
static switch on one trunk automatically changes it on the other.
Format
Example
The following command disables static switch on trunks on the module in
slot 6:
CB5000> set trunk 6 ring_in static_switch disable
Trunk static switch set to DISABLED.
Related Commands
SAVE MODULE_PORT
SET PORT STATIC_SWITCH
SHOW PORT
slot slot (1 through 17) is the slot that contains the trunk ports you are configuring.
enable
Forces users to disable trunks before switching networks. This prevents inadvertent
changes to live rings.
disable
Does not force users to disable trunks down before switching networks.
set trunk static_switch
enable
disable
slot
ring_out
ring_in