Filter
Top Products
2-76
SET BPORT_LEC LEC_DEFAULTS
SET BPORT_LEC
LEC_DEFAULTS
Use the SET BPORT_LEC LEC_DEFAULTS command to restore the LAN Emulation
attributes of a LAN Emulation Client
(
LEC) to the default values listed below.
This command is only effective when the LEC has been disabled by executing
the SET BPORT_LEC MODE command.
BPORT is an abbreviation for Bridge Port.
LEC ports are logical ports, all of which overlay one physical ATM/Synchronous
Optical Network (SONET) port.
Format
Example
The following command sets the default setting of the LEC in slot 4, port 1:
CB5000> set bport_lec 4.1 lec_defaults
Bridge Port 04.01 parameter set. Setting saved.
Related Command
SHOW BPORT_LEC CONFIGURATION
slot.lec Identifies the slot and LEC for this operation.
slot (1 through 17) is the slot number and
lec is one of up to 64 LAN
Emulation Clients defined as logical ports for the ATM Backbone
SwitchModule. For example, to identify LEC 32 on the ATM Backbone
SwitchModule in slot 4, enter
4.32
lec_defaults
The default settings for the LEC.
Attributes Value
config_mode automatic
elan_type unspecified
max_frame_size unspecified
elan_name Zero-length string
("admin" for LEC 1)
les_atm_address Zero-length ATM address
lecs_atm_address Zero-length ATM address
num_elan_vccs <max vccs on module>
control_timeout 120 sec
max_unknown_frame_count 1
max_unknown_frame_time 1 sec
vcc_timeout 1200 sec
max_retry_count 1
aging_time 300 sec
forward_delay_time 15 sec
expected_arp_resp_time 1 sec
flush_timeout 4 sec
path_switch_delay 6 sec
connect_complete_timer 4 sec
set bport_lec lec_defaults
slot.lec