Filter
Top Products
SET BPORT_MAU LINK_INTEGRITY
2-91
SET BPORT_MAU
LINK_INTEGRITY
Use the SET BPORT_MAU LINK_INTEGRITY command to enable or disable link
integrity for MAUs on 10BASE-T SwitchModules. By default, link integrity is
enabled on 10BASE-T SwitchModule MAUs.
In general, enable link integrity for all MAUs on your 10BASE-T SwitchModule
as stated in the 10BASE-T standard. You must disable link integrity to connect
to older non-10BASE-T equipment.
Not all pre-10BASE-T equipment works with link integrity enabled.
You must enable or disable link integrity at both ends of the connection. If the
settings at each end of the connection differ, the MAU with link integrity
enabled reports a link integrity error.
Format
Example
The following command disables link integrity on mau 1 on port 1 on the
10BASE-T module in slot 5:
CB5000> set bport_mau 5.1.1 link_integrity disable
Link integrity set to DISABLED.
Related Command
SHOW BPORT_MAU
slot.port.mau Identifies the MAU for this operation.
slot (1 through 17) is the slot number and port (1 through 24) is the
port number. Use 1 as the mau variable. For example, to identify MAU
1 on port 4 on the module in slot 6, enter
6.4.1
slot.
all
Specifies that all MAUs in the slot are affected by this operation.
disable
Disables link integrity.
enable
Enables link integrity.
slot.
all
set bport_mau link_integrity
disable
enable
slot.port.mau