Filter
Top Products
SET PORT HIGH_POWER
2-181
SET PORT
HIGH_POWER
Use the SET PORT HIGH_POWER command to enable or disable a port from
receiving or transmitting at high power. This command pertains to ONline
Ethernet Port-Switching Fiber Modules (Model Numbers 5102M-FP and
5104M-FP) only.
This command allows you to increase the distance between connections by
setting both ends of the link to high power. You must set this port to normal
power (high_power disabled) to connect to certain ORnet fiber products (Model
Numbers 9301T, 9308, 9314, and 9301A).
Format
Example
The following command enables high power on port 1 on the module in slot 5:
CB5000> set port 5.1 high_power enable
High power optics ENABLED.
Related Command
SHOW PORT
slot.port Identifies the port for this operation.
slot (1 through 17) is the slot number location of a module in the hub
and port (1 through 3) is the port number on the specified module.
For example, to identify port 4 on the module in slot 6, enter
6.4
slot.
all
Specifies that all ports on the module are affected by this operation.
disable
Disables receiving or transmitting at high power.
enable
Enables receiving or transmitting at high power.
slot.
all
set port high_power
disable
enable
slot.port