Filter
Top Products
2-180
SET PORT HALF_STEP
SET PORT HALF_STEP
Use the SET PORT HALF_STEP command to establish if half-step or full-step
mode is used for that port on the ONline Ethernet Transceiver Module.
Refer to the
ONline Ethernet Transceiver Module Installation Guide
for more
information on half-step mode and the Ethernet Transceiver Module.
Format
Example
The following command sets port 2 in slot 7 to full-step mode:
CB5000> set port 7.2 half_step disable
Half_step set to DISABLED.
Related Command
SHOW PORT
slot.port Identifies the port for this operation.
slot (1 through 17) is the slot number location of a module in the hub and
port (1 through 3) is the port number on the specified module. For
example, to identify port 3 on the module in slot 6, enter
6.3
slot.
all
Specifies that all ports on the module are affected by this operation.
disable
Disables half-step signaling. Full-step signaling is used instead. Full-step
signaling is used primarily with non-IEEE 802.3 and earlier Ethernet devices.
enable
Enables half-step signaling. Half-step signaling is used primarily with
IEEE 802.3 and Ethernet Version 2.0 devices and repeaters. This is the
default setting.
slot.
all
set port half_step
disable
enable
slot.port