Filter
Top Products
2-182
SET PORT LINK_INTEGRITY
SET PORT
LINK_INTEGRITY
Use the SET PORT LINK_INTEGRITY command to enable or disable link integrity
for ports on Ethernet 10BASE-T Modules.
In general, enable link integrity for all ports on your 10BASE-T module as stated
in the 10BASE-T standard. You must disable link integrity to connect to older
non-10BASE-T equipment.
Not all pre-10BASE-T equipment works with link integrity enabled.
You must enable or disable link integrity at both ends of the connection. If the
settings at each end of the connection differ, the port with link integrity enabled
reports a link integrity error.
Format
Example
The following command enables link integrity on port 1 of the 10BASE-T
module in slot 5:
CB5000> set port 5.1 link_integrity enable
Link integrity set to ENABLED.
Related Command
SHOW PORT
slot.port Identifies the port for this operation.
slot (1 through 17) is the slot number location of a module in the hub
and port (1 through 4) is the port number on the specified module.
For example, to identify port 4 on the module in slot 6, enter 6.4.
slot.
all
Specifies that all ports in the slot are affected by this operation.
disable
Disables link integrity.
enable
Enables link integrity.
slot.
all
set port
li
n
k
_
i
ntegr
i
ty
disable
enable
s
l
ot.port