Filter
Top Products
SHOW COUNTER
2-329
Example 6
The following command shows Token Ring (DOT5) Statistics for Token Ring
network 1:
CB5000> show counter token_ring token_ring_1
Token Ring Statistics for TOKEN_RING_1
-------------------------------------------------------------------
Ring Status: No Problems Detected Ring State: Opened
Ring Open Status:Ring Open Ring Speed: 16 MBPS
Upstream Station:08-01-20-0c-9e-d7 Functional Addr.: c0-00-00-00-00-00
Active Monitor Selection Participation: Disabled
Line Errors: 0
Burst Errors: 0
AC Errors: 0
Abort Transmitted Errors: 0
Internal Errors: 0
Lost Frame Errors: 0
Receiver Congestion Errors: 0
Frame Copied Errors: 0
Token Errors: 0
Soft Errors: 0
Hard Errors: 0
Signal Losses: 0
Transmit Beacons: 0
Recoveries: 0
Lobe Wires: 0
Removes: 0
Singles: 0
Field Description
Ring Status Current operating status of the ring (refer to the table on the next
page). The Ring Status value is a sum of values, derived from values
for each condition that applies. When a single condition exists, text
displays to describe the condition. When multiple conditions exist,
the value displayed is a hexadecimal number that represents the sum
of all conditions.
Ring State Current interface state in terms of entering or leaving the ring.
Ring Open Status Indicates the success, or the failure reason, for the station’s most
recent attempt to enter the ring.
Ring Speed 4 or 16 Mbps.
Upstream Station MAC address of the Nearest Active Upstream Neighbor of this
station.
Functional Addr. A bit mask that describes the functional addresses for which this
interface accepts frames.
Active Monitor
Selection
Participation
Indicates whether or not this station participates in the Active
Monitor Contention process.