Filter
Top Products
SET MODULE DLM_MODE
2-137
SET MODULE
DLM_MODE
Use the SET MODULE DLM_MODE command to enable or disable DLM
(Dynamically Loadable Module) mode on an A-ENMC. You must enable DLM
mode before the A-ENMC can run DLMs. The factory default is DLM mode
disabled.
Format
Example
The following command enables DLM mode on the A-ENMC in subslot 4 of the
module in slot 15:
CB5000> set module 15.4 dlm_mode enable
Related Command
SHOW DLM
slot.subslot Identifies the slot and subslot for this operation.
slot
(1 through 17) is the slot number in the hub and subslot (2 through 7) is
the subslot number on the module in the specified slot. For example, to
identify subslot 4 of slot 15, enter
15.4
disable
Disables DLM mode.
enable
Enables DLM mode.
set module
slot.subslot
disable
enable
dlm_mode