Filter
Top Products
2-238
SET SECURITY_ADVANCED ADDRESS_TABLE ADDRESS
SET
SECURITY_ADVANCED
ADDRESS_TABLE
ADDRESS
Use the SET SECURITY_ADVANCED ADDRESS_TABLE ADDRESS command to
manually configure your security address table for the Ethernet Private Line
Card.
In some instances, it is preferable to manually configure your security address
table. For example, if you work in an environment that demands a high level of
security, you may not want to enable autolearning on a secure network.
In this type of environment, manually add users to the security address table.
To add address information to your table manually, you can enter either:
■
A MAC address and associated port
■
A MAC address and associated group code
The host module cannot autolearn group codes. You
must
set them manually.
Format
Example
The following command adds a MAC address and port 5.1 to your security
address table:
CB5000> set security_advanced address_table address
40-40-34-e5-00-23 port 5.1
Security Address Table update in progress...
Related Command
SHOW SECURITY_ADVANCED
address Address you want to add to the security address table.
all
Adds all addresses to this port or group.
delete
Deletes the indicated MAC address, or all MAC addresses, from the
address table.
slot.port Identifies the port for this operation.
slot (1 through 17) is the slot number location of a module in the hub
and port (1 through 40) is the port number on the specified module.
For example, to identify port 4 on the module in slot 6, enter
6.4
group Specifies a port group which to apply this command.
set security_advanced address_table address
address
slot
.port
group
group
port
all
delete