Filter
Top Products
2-172
SET NETWORK TOKEN_RING RING_SPEED
SET NETWORK
TOKEN_RING
RING_SPEED
Use the SET NETWORK TOKEN_RING RING_SPEED command to set the ring
speed for any CoreBuilder 5000 Token Ring backplane (hub-wide) or isolated
(module-level) network. Any module, port, trunk, or daughtercard assigned to
the network is set automatically to the speed of the network.
This setting is saved automatically, and is not affected by the SAVE or REVERT
commands.
When DIP configuration is enabled, and there is a conflict between the ring
speed DIP settings on different modules set to the same network, there is no
way to determine which speed will be selected. This is because the DMM
controls network speed resolution.
Format
Example
The following command sets the ring speed for backplane network
token_ring_4 to 16 Mbps:
CB5000> set network token_ring token_ring_4 ring_speed 16_mbps
Value set to 16 MBPS.
Related Commands
SET MODULE RING_SPEED
SHOW MODULE
set network token_ring ring_speed
4_mbps
16_mbps
token_ring_1...
token_ring_10
isolated_1
isolated_10
slot
slot Identifies the module for this operation.
4_mbps
Sets the ring speed to 4 Mbps.
16_mbps
Sets the ring speed to 16 Mbps.